Threat a bobber stop on the line as usual, instead of adding the bobber/float neaxt add a svivel right below the stopper. Then add a couple of split shots and attach the hook as usual. The svivel allows for a quick change of the bobber/float as needed. If the bobber/float only has an in-line application, threat a 10# line through the hole and tie it off with a loop knot on the bottom.
Kai, is that technique you posted above the same 1 you showed me @ Inks Lk.? I need to get some of those rubber/plastic black things you used to thread the line & bobber. Hope I don't 4get b4 Calaveras in May. 
"Thanx" for sharin the info. L8r. James,"VATO LOCO" 
<;({})><
It's been a while since this topic was active, if you'd like to get it going again, please post as a registered member
