I am going to be using some fluorcarbon line on one of my rods. I haven't used the line before, so I am looking for suggestions as to which would be the best knot to use ?? Any info would be much appreciated, thanks !
Stewards of our fishing resources and promoting good sportsmanship!
Page
1
posts 1–7 of 7
guest poster
+0
permalink
Carol,
pretty much any knot will work. You should get some "Knot Glue", which is similar to super glue. That will prevent the knot from slipping or getting lose. That stuff also works with any other line.
Good luck.
+0
permalink
intexas2: 1st Off Hope Alls Well With You* I came across this Web-Site that's "VERY" related to your ? 'bout knots! 
http://www.animatedknots.com/ Then Click on Fishing! Check it out, it's got alot of Good Info. "Take Care"! Also be "SURE" to moisten your knot before you tighten it, "ALWAYS"! L8r. James,"VATO LOCO" 
<;({})>< ( Trilene Flourocarbon-Berkley line Good 2). Personally I use 15-25# line.
+0
permalink
Thanks for the info...to be honest, I've been using a "hangman's knot" since I can remember for all my fishing needs... I wasn't sure if it would hold with the fluorocarbon... I'll give the "glue" a shot.
+0
permalink
intexas2: Carol, I Personaly use the Improved Clinch-Knot, With a Carolina Rig! It's The 1 I always use, Hasn't Let Me Down* I Caught Dem Monster Black Drums With That Set-Up! "Take Care" L8r. James,"VATO LOCO" <;({})><
guest poster
+0
permalink
I use the polimar knot for everything. It takes a little more line to tie it, but it never comes lose.
Page
1
posts 1–7 of 7
This Topic Is Locked To Guest Posts
It's been a while since this topic was active, if you'd like to get it going again, please post as a registered member
